50BMG

[FTB1-SS]

I am looking for a sizing die for 50BMG bullets, any suggestions on what and where to get?

[swedishmeat]

Check with Lee, they sold one for about $30.00.
also check with midway and Graf & Sons. I would call them, as the low inventory items are not always listed. They go up to $90.00,( that I remember), but you usually get what you pay for.
Good luck.

[Kali Komrade]

I am looking for a sizing die for 50BMG bullets, any suggestions on what and where to get?

Quick run down chief... The Lee Die sets are 1- 1/4 inches verses everyone else that is set up for 1- 1/2 inches... so makes sure you buy something that is compatible for your press... I like the Lee Dies they even sell a crimp die for the 50bmg my suggestion if you go Lee is go with the complete press and die set through midwayusa.com...

Reason why I bring this up is I had to have one of our local 50 cal dealers call CH4 tool and die and have them make me a custom bullet puller for the 50bmg to fit in the Lee Press as the little 50cal pullers couldn't do the job properly...

[Geo.Az]

I am Curious what did CH4D Charge You?

[Kali Komrade]

I am Curious what did CH4D Charge You?

From what I recall it was like 150$ Geo... Wasn't too bad but was the only company at the time that would do a custom job for the Lee Press... :banghead: